Valve Timing

From Frank Williams, Locomotive Valve Setting, 1944:

Valve setting is a term generally applied to the work of making the final accurate adjustments to the valves and the valve gear of a locomotive before it is placed in service. These adjustments are made in order that the positions of the valves shall at all times bear their proper relation to the positions of the pistons. Valve setting follows the erection or hanging of the valve gear by the machinist.

Dead Center

See Dead center

Valve Formulas

From Larry Koehl, Live Steam Magazine, June 1976

The Throw of Eccentric formula, below, applies only to locomotives using Stephenson valve gear.

Larry suggests adding up to 0.002 inches to the Throw of Eccentric value for each pin in the valve gear (including the eccentric, too) because, even when new, there will be lost motion, possibly enough to eliminate the lead.

Larry also points out the fact that Cut-Off is always 75% when Lap equals Port Width, for all values of Port Width.

Stephenson

Ian wrote on Little Engines Yahoo Group:

When the reversing lever (Johnson Bar) is in mid gear position there WILL be movement of the valve spindle however it will be at a minimum.

With the covers off the valve/steam chest then with the lever/bar centred (mid gear) the valve should just open the ports and it should be symmetrical at top and bottom dead centre respectively.

Better to set the eccentrics at full gear so that the valve only just cracks the ports at TDC/BDC and adjust the spindle length or slide position so it is symmetrical. just as you would a non reversing engine. This adjustment can be done without taking the cover off if the boiler has some low pressure air it and tubes connected to the drain cocks are led into a jar of water. Bubbles from the tube indicates the port is just opening.

Walschaert

See

• A Suggestion for Setting Out Walschaerts Gear

• WALSCHAERTS' VALVE GEAR FOR WORKING MODELS

External Links

• "Valve Gear and Valve Events"
• "Steam Engines", Project Gutenburg
• "Cylinder Design", The Great Western Archive
• "The Mechanics of the Miniature Steam Engine
• "Steam Engine Indicator Diagram"
• A Few Useful Shop Hints On Locomotive Valve Setting
• One thousand pointers for machinists and engineers..., see page 90 for valve timing
• "Steam Engine Pressure-Volume Diagram"
• "2-8-2 Heavy Mikado valve timing", livesteam.com
• "Steam Cutoff - Part 1 - Fun with Efficiency", PLS Gazette
• "Steam Cutoff - Part 2 - More Fun With Efficiency", PLS Gazette
• "Finding Locomotive Dead Centers", Jeffrey G. Hook
• "Steam Engine Steam Cutoff Explained"
• Locomotive Valves and Valve Gears, with a Special Treatise on Valve Setting
• Allen Models of Michigan catalog contains a write-up on how to set valves for an Stephenson Valve Gear.
• "The Company Notch", DiscoverLiveSteam.com