Taper pin: Difference between revisions
No edit summary |
No edit summary |
||
Line 99: | Line 99: | ||
</center> | </center> | ||
== Reamer == | |||
[[File:TaperPinReamers.jpg|thumb|right|300px|Various styles of taper pin reamers]] | |||
The taper pin hole is drilled to the size of the small end of the taper through both the collar. Longer pins may required step-drilling part through the hole (see table above). The hole is completed using a taper pin reamer of the same same. | |||
== Application == | == Application == |
Revision as of 19:38, 14 August 2014
A tapered pin is a fastener used in mechanical engineering. They are steel rods with one end having a slightly larger diameter than the other. Standard inch-sized tapered pins have a taper on diameter of 1:48 while metric ones have a taper of 1:50. A 1:48 taper means that one end of a 4-foot-long bar (48 inches) will be 1 inch smaller in diameter than the other end, or a 1/4-inch taper over a 1-foot length.
The diameter at the small end of ASME Taper Pins is a function of the length and should be specified as a reference dimension for determining drilled hole size. It shall be computed by multiplying the nominal length of pin by the factor 0.2083 and subtracting the result form the basic pin diameter.
No. of Taper Pin | Diameter Large End D | Approx. Size D | 1st Drill thru size | Second Drill | |
---|---|---|---|---|---|
Size | Depth | ||||
#7/0 | 0.0625 | 1/16 | 0.0469 | ||
#6/0 | 0.078 | 5/64 | 0.0469 | ||
#5/0 | 0.094 | 3/32 | 0.0625 | ||
#4/0 | 0.109 | 8/64 | 0.0781 | ||
#3/0 | 0.125 | 1/8 | 0.0938 | ||
#2/0 | 0.141 | 9/64 | 0.0938 | 0.1094 | 1-1/4 |
#0 | 0.156 | 5/32 | 0.0938 | 0.1250 | 1-1/2 |
#1 | 0.172 | 11/64 | 0.1094 | 0.1406 | 1-1/2 |
#2 | 0.193 | 3/16 | 0.1094 | 0.1406 | 1-3/4 |
#3 | 0.219 | 7/32 | 0.1406 | 0.1719 | 1-3/4 |
#4 | 0.250 | 1/4 | 0.1719 | 0.2031 | 1-3/4 |
Reamer
The taper pin hole is drilled to the size of the small end of the taper through both the collar. Longer pins may required step-drilling part through the hole (see table above). The hole is completed using a taper pin reamer of the same same.
Application
- When I worked for IBM we still had card machines when I started that used taper pins all over the place. We were issued an assortment of taper pins about 3 inches long in different sizes. The standard procedure was to put a new pin in the hole and ream the hole if necessary. The new pin was marked on each end, then nick the pin with a file just outside the gear or pulley, break off the unneeded ends, dress the ends with a file and drive it home.