File:Drill Centering into vee block.jpg

No higher resolution available.

Drill_Centering_into_vee_block.jpg ‎(184 × 240 pixels, file size: 16 KB, MIME type: image/jpeg)

Hold a center in the chuck of your drill or mill and line it up with the center of a clamped vee block. From "Cross Drilling" by Stan Bray, "World of Model Engineering" No 3, 1989, http://www.model-engineer.co.uk/sites/7/documents/wome-3-pt3.pdf

File history

Click on a date/time to view the file as it appeared at that time.

	Date/Time	Thumbnail	Dimensions	User	Comment
current	16:20, 17 May 2013		184 × 240 (16 KB)	Dnevil (talk \| contribs)	Hold a center in the chuck of your drill or mill and line it up with the center of a clamped vee block. From "Cross Drilling" by Stan Bray, "World of Model Engineering" No 3, 1989, http://www.model-engineer.co.uk/sites/7/documents/wome-3-pt3.pdf

You cannot overwrite this file.

The following page uses this file:

This file contains additional information, probably added from the digital camera or scanner used to create or digitize it.

If the file has been modified from its original state, some details may not fully reflect the modified file.

Author	Daris Nevil
Date and time of data generation	16:18, 17 May 2013
Date and time of digitizing	16:18, 17 May 2013
DateTimeOriginal subseconds	49
DateTimeDigitized subseconds	49